Table of Contents
Advertisement
STATus:QUEStionable:CONDition?
Syntax
STATus:QUEStionable:CONDition?
This command queries the condition register for the Questionable Data
register group and returns a decimal value which corresponds to the
binary-weighted sum of all bits set in the condition register
page 302). For example, if bit 0 (decimal value = 1) and bit 2 (decimal value =
4) are set, this command will return the decimal value "+5".
N O T E
Remarks
• A condition register continuously monitors the state of the instrument. The
• The condition register bits reflect the current condition of the instrument.
Example
& STAT:QUES:COND?
$ +4096
See also
"STATus:QUEStionable:ENABle"
"STATus:QUEStionable[:EVENt]?"
U3606B Programmer's Reference
This is a read-only register and the bits are not cleared when you read the
register. For more information on the bit definitions of the Questionable
Data register and the SCPI status diagram see the
System"
on page 12.
bits in the condition register are updated in real time and the bits are not
latched or buffered.
If a condition goes away, the corresponding bit is cleared in the condition
register. A Factory Reset (*RST command) will clear all bits in the
condition register.
STATus:QUEStionable:CONDition?
This command reads the condition register
(bit 12 is set).
on page 302
on page 304
STATus Subsystem
12
(Table 12-2
on
"SCPI Status
301
Advertisement
Table of Contents
