[Source:]Current:limit - Agilent Technologies U3606B Programmer's Reference Manual

[SOURce:]CURRent:LIMit

Syntax
[SOURce:]CURRent:LIMit <value>[,<save>]
This command sets the over-current limit for the constant voltage output. If
the load effect exceeds the over-current limit setting, the instrument output
will be dropped down to meet the over-current limit setting.

[SOURce:]CURRent:LIMit?

This query returns a numeric value that represents the over-current limit
value of the constant voltage output.
Parameter
value
save
[1]
Remarks
• If the over-current limit value is set to zero, the instrument output will be
• If the over-current limit value is set to a greater value than the over-current
• The [SOURce:]CURRent:LIMit command is not applicable for
• If the <save> value is set to "1" or "ON", the limit value set will be stored to
U3606B Programmer's Reference
Item Type
Numeric
Boolean
If the <save> value is omitted, the [SOURce:]CURRent:LIMit command will not store the
limit value to the U3606B's nonvolatile memory.
dropped down to zero for limiting.
protection value, the over-current protection value will be adjusted to equal
the over-current limit value.
square-wave output, range S1S2 (autoranging), and 4-wire resistance
measurements (Lo Ω).
the U3606B's nonvolatile memory.
Range of values
Range Min
S1 0 A
S2 0 A
S2m 0 A
[1]
0|1|OFF|ON
SOURce Subsystem
[SOURce:]CURRent:LIMit
Default value
Max
1.05 A 1 A
3 A
3.15 A
3 A
3.15 A
0
11
265