Agilent Technologies U3606B Programmer's Reference Manual page 127

• If the input signal is greater than can be measured on the selected range
• If a range change is in progress (due to the autoranging setting) when you
Example
& CONF:AC
& CONF:PWID
& READ?
$ +2.403553E-05
See also
"CONFigure?"
"CONFigure[:VOLTage]:AC"
"CONFigure:CURRent:AC"
"INITiate[:IMMediate]"
"FETCh?"
"READ?"
U3606B Programmer's Reference
(manual ranging), the instrument gives an overload indication.
• Positive overload: "+9.900000E+37" or "OL" from the front panel.
• Negative overload: "-9.900000E+37" or "–OL" from the front panel.
query the instrument, the value "+9.910000E+37" will be returned. Wait
for the instrument to select an appropriate range before querying the
instrument again.
on page 80
on page 329
on page 331
This command configures the instrument for
AC voltage measurements. The default range
(autorange) and resolution (5½ digits) are used.
This command configures the instrument for
pulse width measurements via the voltage
path. The range and resolution follows the
configuration of the AC voltage function.
This command places the instrument in the
"wait-for-trigger" state, triggers a
measurement, and sends the reading to the
instrument memory and output buffer.
on page 84
on page 93
on page 120
CONFigure Subsystem
CONFigure:PWIDth
4
115