SYSTem:BEEPer:STATe
Syntax
SYSTem:BEEPer:STATe {0|1|OFF|ON}
This command enables or disables the beeper tone.
The valid options are:
• 0|OFF: Disables the beeper tone
• 1|ON: Enables the beeper tone
SYSTem:BEEPer:STATe?
This query returns a boolean value that represents the beeper state of the
instrument.
Parameter
state
Remarks
• A beep tone is emitted only if the beep state is ON in the following cases:
• The beeper setting is stored in nonvolatile memory, and does not change
U3606B Programmer's Reference
Item
Type
Boolean
•
An error is generated.
•
A set low or high limit is exceeded in a limit test.
•
A stable reading is captured in the reading hold mode.
•
A forward-biased diode is measured in the diode test function.
when power has been off, after a Factory Reset (*RST command), or after
an Instrument Preset (SYSTem:PRESet command).
Range of values
0|1|OFF|ON
SYSTem Subsystem
SYSTem:BEEPer:STATe
Default value
1
13
307