Table of Contents
Advertisement
7
MEASure Subsystem
MEASure[:VOLTage][:DC]?
MEASure[:VOLTage][:DC]?
Syntax
MEASure[:VOLTage][:DC]?
This command first resets all DC voltage measurement parameters and trigger
parameters to their default values. Then, it configures the instrument for DC
voltage measurements and immediately triggers a measurement. A single
reading is returned.
Parameters
range
resolution
Remarks
• You can allow the instrument to automatically select the measurement
132
[<range>|AUTO|MAX|MIN|DEF[,{<resolution>|MAX|MIN|DEF}]]
Item
Type
Numeric
Numeric
range using autoranging or you can select a fixed range using manual
ranging. Autoranging is convenient because the instrument decides which
range to use for each measurement based on the input signal. For faster
measurements, use manual ranging on each measurement (some additional
time is required for autoranging since the instrument has to make a range
selection).
Range of values
• 20 mV|MIN
• 100 mV
• 1 V
• 10 V
• 100 V
• 1000 V|MAX
• AUTO
• MAX (4½ digit)
• MIN (5½ digit)
•
1 uV
•
10 uV
•
100 uV
•
1 mV
•
10 mV
•
100 mV
Default value
AUTO
MIN
•
0.1 uV
•
1 uV
•
10 uV
•
100 uV
•
1 mV
•
10 mV
U3606B Programmer's Reference
Advertisement
Table of Contents
