Table of Contents
Advertisement
Adaptive Cruise Control (ACC)/Forward
Collision Warning (FCW) Sensor Protective
Cover — If Equipped
Your vehicle may be equipped with a protective
cover that is to be used whenever the
windshield is folded down in order to protect the
ACC/FCW sensor. To install the cover, follow the
instructions below:
1. Secure the top part of the cover so that it
hinges to the header.
2. Swing the cover down and push on it so that
it covers the opening.
3. Check to make sure the cover is secured
properly.
Protective Cover Installed
NOTE:
Be sure to remove the cover before returning
the windshield to the normal position. Store the
cover in the cargo area.
Cleaning Instructions
During windshield down applications, dust/dirt
can accumulate in the cover and block the
camera lens. Use a microfiber cloth to clean the
camera lens, module, and inside cover, being
careful not to damage or scratch the module.
R
T
W
AISING
HE
INDSHIELD
1. Release the strap that secured the
windshield in the lowered position.
2. Raise the windshield.
3. Using the provided #T40 Torx head driver,
reinstall the four Torx head fasteners
located along the interior of the windshield
(two on each side of the header trim).
Secure them until they are snug, being
careful not to cross-thread the fasteners or
overtighten.
GETTING TO KNOW YOUR VEHICLE
Step Three
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
4. Reinstall the windshield wiper arms using
the provided 15 mm socket. First, align the
tips of the blade to the "T" mark in the glass.
Then, while holding the arm in that position,
reinstall the hex nut and tighten until snug.
Be careful not to overtighten. Repeat for the
other arm.
87
2
Advertisement
Table of Contents
