Raising The Windshield; Hood; Opening The Hood - Jeep Gladiator 2024 Owner's Manual

Cleaning Instructions
During windshield down applications, dust/dirt can
accumulate in the cover and block the camera lens.
Use a microfiber cloth to clean the camera lens, mod-
ule, and inside cover, being careful not to damage or
scratch the module.

RAISING THE WINDSHIELD

1. Release the strap that secured the windshield in the
lowered position.
2. Raise the windshield.
3. Using the provided #T40 Torx head driver, reinstall
the four Torx head fasteners located along the inte-
rior of the windshield (two on each side of the
header trim). Secure them until they are snug, being
careful not to cross-thread the fasteners or
overtighten.
Step Three
1 — Outer Torx Fasteners
2 — Center Torx Fasteners
4. Reinstall the windshield wiper arms using the pro-
vided 15 mm socket. First, align the tips of the
blade to the "T" mark in the glass. Then, while hold-
ing the arm in that position, reinstall the hex nut and
tighten until snug. Be careful not to overtighten.
Repeat for the other arm.
5. Reinstall the protective caps over the wiper arm hex
bolts and push gently until they snap into place.
Step Five
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
NOTE:
Make sure the windshield is raised prior to installing
the tops.
GETTING TO KNOW YOUR VEHICLE

HOOD

OPENING THE HOOD

Release both of the outside hood latches.
Hood Latch Locations
Raise the hood slightly, locate the safety latch in the
middle, and push the latch to the right to open.
Hood Safety Latch Lever Location
91
2