Table of Contents
Advertisement
RAISING THE WINDSHIELD
1. Release the strap that secured the windshield in the
lowered position.
2. Raise the windshield.
3. Using the provided #40 Torx head driver, reinstall
the four Torx screws located along the interior of the
windshield. Secure them until they are snug, being
careful not to cross-thread the screws or
overtighten.
Interior Torx Screw Locations
1 — Outside Torx Screws
2 — Inside Torx Screws
4. Reinstall the windshield wiper arms using the pro-
vided 15 mm socket. First, align the tips of the
blade to the "T" mark in the glass. Then, while hold-
ing the arm in that position, reinstall the hex nut and
tighten until snug. Be careful not to overtighten.
Repeat for the other arm.
5. Reinstall the protective caps over the wiper arm hex
bolts and push gently until they snap into place.
Step Five
1 — Hex Bolt Cover Installed
2 — Hex Bolt Cover Removed
6. After completing the steps above:
○
If your vehicle is equipped with a Soft Top, rein-
stall the Door Rails and raise the top.
○
If your vehicle is equipped with a Hard Top, rein-
stall the Freedom Panels.
HOOD
OPENING THE HOOD
If applicable, refer to the "Hybrid Supplement" for addi-
tional information.
Release both of the outside hood latches.
GETTING TO KNOW YOUR VEHICLE
Hood Latch Locations
Raise the hood slightly, and place a hand palm-side
down in the center of the hood opening. Locate the
safety latch in the middle, and push the latch to the
right to open.
Place Hand In Hood Opening
Remove the support rod from the hood, and insert it
into the radiator crossmember.
97
2
Advertisement
Table of Contents
