Setting Up Cts Components; Setting Up The Displays - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 15 First-Time Setup
Your system saves the changes and restarts.

Setting Up CTS Components

This section includes the steps you use to test and configure the system components and includes the
following sections:
•
•
•
•
•
•

Setting Up the Displays

A display is set up correctly when the color on the display has been adjusted for the lighting in the
meeting room. Each display must be set up individually.
To set up the displays, complete the following steps.
Using the IP address that appeared on the display during system bootup, log in to the CTS
Step 1
Administration GUI.
Tip If you did not make a note of the IP address, follow the instructions in
"Configuring an Alternate TFTP Server (Optional)" section on page 15-5
Navigate to Hardware Setup > Troubleshooting > Displays.
Step 2
Click Start to begin the adjustment process.
Step 3
Each display in the meeting room should now be showing a set of horizontal grey bars and that display's
relative position.
Select the color temperature of the lighting in the meeting room and click Apply.
Step 4
OL-27038-01
The following example gives the Cisco TelePresence system an IP address of 10.0.0.2, a subnet of
255.255.255.0, a gateway of 10.0.0.1, a DNS server of 172.16.1.5, and a domain name of cisco.com:
admin:set network IP static 10.0.0.2 255.255.255.0 10.0.0.1 172.16.1.5 cisco.com
ip address successfully set
system restarting...
Setting Up the Displays, page 15-7
Setting Up the Cameras, page 15-9
Setting Up the Speakers, page 15-23
Setting Up the Microphones, page 15-24
Setting Up the Presentation Display, page 15-26
Other Devices, page 15-28
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Setting Up CTS Components
Step 5 and Step 6 in the
to retrieve it.
15-7