Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 382

Setting Up CTS Components
Align the top edges of the rear panels by completing the following steps:
Step 2
a.
b.
c.
You perform additional leveling after you install the top bezel; however you do not install the top bezel
Note
until after you zoom and focus the cameras and attach the camera hood. For the additional leveling
procedures, see the
Figure 15-14 Aligning the Bezel With the Adjoining Panels
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
15-20
If needed, align the inner top corner of right rear panel to adjacent corner on center panel.
Tighten the upper screw using a #4 phillips bit or screwdriver.
Perform the same steps on the left rear panel.
"Setting Up the Cameras" section on page 15-9
Chapter 15 First-Time Setup
in Chapter 15, "First-Time Setup."
OL-27038-01