Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 289

Chapter 13 Building the Second Row Table For a 14- and 10-Seat TX9200 System
Join table leg 800-37776-xx, table leg 800-37777-xx, and the privacy panel bracket together by
Step 6
completing the following procedure:
Note
d. Attach a privacy panel bracket (callout 1 in
800-37777-xx (callouts 2 and 3).
Line up the alignment pins to the holes and attach the panel with eight M8 x 16mm screws (callout
e.
4).
These screws, and all screws that attach the privacy panel to the table legs, attach from the rear of
the system.
and facing the second row.
Check that the top surface of each leg are the same height and are level by placing levels on the
f.
following places:
Set a level on the side of the leg to align the legs vertically.
•
Set a level on top of the table leg, both parallel to and perpendicular to the table leg.
•
Note
Do not fully tighten all the screws until you attach all of the table sections.
Tip
Caution USE THE CORRECT M8 x 16mm SCREWS FOR THIS STEP.
shoulder washers.
OL-27038-01
For this step and all successive steps, slightly peel back the protective film on the table legs
(enough to expose the space where the structure and the legs join together).
Figure 13-34 shows the table legs as if you were standing from the front of the system
You can also use a laser level for this step.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Assembling a 4-Seat Second Row For a 10-Seat TX9200 System
Figure 13-34) in between 800-37776-xx and
The correct screws do not have
13-43