Replacing the Center Display—Part Number CTS-DISP-65-GEN4=
Power the system on, and close bottom facade panels.
Step 41
Replacing the Center Display—Part Number
CTS-DISP-65-GEN4=
This procedure describes how to replace the display and includes the following sections:
•
•
Required Tools
A #4 phillips screwdriver is required.
Replacing the Center Display
To replace a display:
Open the bottom facade panels, and power off the system by turning the power switch on the four PDUs
Step 1
to the "OFF" position.
Step 2
Remove the top bezel.
See
Remove the bottom bezel.
Step 3
See
Remove the two center LED light fixtures.
Step 4
See
Disconnect the LED light plug from the panel-mount connector in the center top panel
Step 5
Squeeze together the ends of the clips on the light cable connector, and remove it from the center top
Step 6
panel.
See
Remove two center-most access panels.
Step 7
See
Remove the center top panel.
Step 8
See
Step 9
Remove the center rear panel.
See
Step 10
Unplug the two speaker cables that connect the speakers to the audio/video extension unit. Do not
disconnect the speaker cables connecting the two speakers.
Step 11
Unplug the camera cables from the camera processor.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
17-12
Required Tools, page 17-12
Replacing the Center Display, page 17-12
Figure 15-13
for more information.
Figure 14-14
for more information.
Figure 14-12
for more information.
Figure 14-11
for more information.
Figure 15-16
for more information.
Figure 14-10
for more information.
Figure 14-5
for more information.
Chapter 17
Field-Replaceable Unit Guide
OL-27038-01