Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 320

Install the center rear panel by completing the following steps:
Step 3
a.
Note
b.
c.
d.
Key Part Description
1 Center rear panel
2 M8 x 16mm pan head screw
3 Clear plastic washer
4 Top covers
5 Screw slots
6
Hanger
Figure 14-5 Installing the Center Rear Panel (1 of 2)—Description of Parts
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
14-6
Systems with free-standing reflector walls only: Remove the top covers from the center rear panel.
Using a box cutter or tin snips, cut through the thin sections of the plastic tabs that hold the covers
in place. One of the two covers is shown as callout 4 in
If your system uses a reflector wall that mounts to the wall, skip this step and continue to Step
Hook the hanger of the panel (callout 6 in
Add the M8 washers to the M8 x 16mm screws, then insert the screws in the screw holes to attach
the center rear panel to the display structure. See
Tighten the screws using a #4 Phillips screwdriver or driver bit.
Part Number
700-37189-01
Kit # 69-2311-xx
48-3012-01
Kit #69-2365-xx
49-1377-01
Kit # 69-2369-xx
N/A
N/A
N/A
Chapter 14 Completing Installation of the Main Display Structure
Figure 14-5.
Figure 14-5) into the slot on the display structure.
Figure 14-6 for more information.
Qty Ctn Notes
1 4
4 6
4 6
N/A Part of center rear panel
N/A Part of the panel. The washers and
screws go into these slots.
N/A Part of the panel.
b.
OL-27038-01