Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 203

Chapter 11 Completing Installation of the First Row Table
Attach and route the Ethernet cables for the Cisco TelePresence Touch device and shared presentation
Step 5
cable by completing the following steps:
a.
b.
c.
d.
e.
Key Part Description
1
Presentation cable + audio, 8 meters,
VGA-to-VGA
or
Presentation cable + audio, 8 meters,
HD video (uses HDMI
connector)-to-HD video (uses HDMI
connector)
or
Presentation cable + audio, 8 meters,
DisplayPort-to-HD video (uses
HDMI connector)-to-
or
Presentation cable + audio, 8 meters,
Mini DisplayPort-to-HD video (uses
HDMI connector)
2 6 meter (20 foot) Ethernet cable (for
Cisco Touch)
3 Cable Guide
4 M4 flat head screw
OL-27038-01
Slide the cables for the presentation display sharing and Touch device through the brackets on the
center structure and through the cable exit on the center table. See
TX9000 and TX9200 Systems" section on page 10-17
When you ordred your system, you ordered either an HD video (uses HDMI connector)-to-VGA,
HD video (uses HDMI connector)-to-HD video (uses HDMI connector), DisplayPort-to-HD video
(uses HDMI connector), or HD video (uses HDMI connector)-to-Mini Displayport cable. Be sure
that you choose the correct connector type (VGA, HD video (uses HDMI connector), DisplayPort,
or Mini-DisplayPort) for your conference participants. Replacing the presentation cable is difficult
after your system is completely installed.
Pass the cables separately through one of the openings in the truss (the V-shaped wings that are
shown in Figure 11-9)—one on the left truss, and one on the right.
After you route the cables through the trusses, route the cables through the cable guide so that the
Ethernet cable goes through the cable guide channel nearest the displays and the cable for the
presentation display goes through the channel farthest away from the displays.
Secure the cable guide (callout 3) into place with three screws (callout 4). Ensure that the CISCO
logo faces the conference participants.
Make sure that there is enough slack in the cables that exit the table.
Allow enough slack in the presentation cable so that it can reach the farthest participant.
•
Allow approximately three feet (1 meter) of slack for the Cisco Touch device.
•
Part Number
37-1406-01
CTS-CAB-VGA-A
CAB-HDMIHDMI-A
37-1484-01
69-2346-01
700-37274-01
Kit # 69-2333-xx
48-1943-01
Kit # 69-2355-01
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
"Wiring Diagrams for CTS
for the connections.
Qty Ctn Notes
1 46 Choose either the
presentation cable with the
VGA connectors or the cable
with the HDMI connector),
you cannot connect both.
1 13
1 10
3 6
11-11