Labeling The Cables - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Connecting and Routing the Cables
Revised: May 20, 2015, OL-27038-01
This chapter provides you with information about connecting and routing the cables for the system,
including first row table assembly, and includes the following sections:
•
•
•
•
•
•
To continue installation of the first row table and start cabling of the system, complete the following
steps.

Labeling the Cables

The following label kits are included with the TX9000 and TX9200:
Table 10-1
Part Number
69-2345-01
69-2346-01
69-2347-01
69-2348-01
69-2349-01
69-2350-01
69-2351-01
(TX9200 only)
Figure 10-1
OL-27038-01
Labeling the Cables, page 10-1
Labeling the Display Frame and Cable Runner, page 10-3
Connecting and Routing Cables and Continuing Assembly of the First Row Table, page 10-5
Connecting and Routing Cables in the Main Display Assembly, page 10-14
Wiring Diagrams for CTS TX9000 and TX9200 Systems, page 10-17
Where to Go Next, page 10-23
Cable Kits
Description
Kit1—Cable Kit for TS1 Codec
Kit 2—Cable Kit for TS2 Codec
Kit 3—Cable Kit for TS3 Codec
Kit 4—Cable Kit for TS4 Codec
Kit 5—Cable Kit for System Cables
Kit 6—Cable Kit for First Row
Kit 7—Cable Kit for Second Row (TX9200 only)
shows an example of a label sheet for one of the cable kits.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
10
C H A P T E R
Ctn
12
13
14
15
16
17
48
10-1