Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 229

Chapter 12 Building the Second Row Table (TX9200 Systems Only)
Connect the power cables, and route and connect the power and Ethernet cables, by completing the
Step 23
following steps:
a.
b.
c.
d.
e.
For additional cabling information, see
Note
Key Part Description
1 Table leg side panel assembly, second
row left
2 Table leg side panel assembly, second
row right
3 Table leg side panel assembly, second
row far right
4 Table leg side panel assembly, second
row far left
5
Velcro straps
6
Power jumper cables
OL-27038-01
Attach jumper cables to the second row PDUs and route the cables to the right (the side nearest table
leg K). These cables are shown in blue in
Use two jumper cables to connect the power outlets for legs E, F, and G. You connect a total of six
jumper cables.
Route the cables for the second row table as shown in
Place the power cables in the bottom row of the cable trays.
•
• Place the Ethernet cables in the middle row of the cable trays.
Neatly bundle any excess cable and secure the cables with Velcro straps (callout 1).
Use Velcro straps (callout 1) to cleanly route the cables.
Attach the table leg side panel assemblies (callouts 2, 3, 5, and 6).
Level the table assembly using a laser level and the diamond marks on the sides of the legs as a
reference point.
Part Number
700-37182-xx
Kit # 800-37777-xx
Subkit # 69-2314-xx
700-37183-01
Kit # 800-37777-xx
Subkit # 69-2314-xx
700-37722-01
Kit # 800-37778-xx
Subkit # 69-2314-xx
700-37721-01
Kit # 800-37776-xx
Subkit # 69-2314-xx
52-0499-xx
Kit # 69-2403-xx
Subkit # 53-3789-xx
37-0833-xx
Kit # 69-2351-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Figure 12-16.
Figure
Chapter 10, "Connecting and Routing the Cables."
Qty Ctn
6 51
6 51
1 51
1 51
70 6
6 48
Assembling the Second Row Table
12-16.
Notes
Not shown in
Figure 12-16
Not shown in
Figure 12-16
12-19