Table of Contents
Advertisement
Chapter 15
First-Time Setup
Attach the large target to the underside of the center table section by placing the round pads on the
Step 2
underside of the clamps into recesses that are drilled under the table.
You can feel under the table to find the small round recesses.
Tip
The target pattern should face the camera.
In the Cisco TelePresence administrative GUI, navigate to Hardware Setup > Troubleshooting >
Step 3
Cameras.
Click Start to begin the camera setup. You should see output from each camera in the appropriate camera
Step 4
display area.
Click Setup under the image of the center display screen.
Step 5
If you need further information about testing or adjusting this device, click Help in the content area or
see the troubleshooting charts in this section.
OL-27038-01
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Setting Up CTS Components
15-11
- Quick Links:
- Introduction
Hide quick links:
Advertisement
Table of Contents
