Configuring The Dmp Video For Use With The Cts 500 - Cisco TelePresence System Series Hardware Upgrade Manual

Chapter 2 Options for the Cisco TelePresence System 500-37
Step 2 Connect the audio for the DMP to the DMP Audio connection on the codec. See
connection.
Figure 2-2 Audio Connection for DMP
External Presentation
Presentation Source In

Configuring the DMP Video for Use with the CTS 500

To configure the audio and video software for correct functioning with the CTS 500, complete the
following steps:
Log into the CIsco TelePresence System administrative GUI.
Step 1
Navigate to Troubleshooting > Hardware Setup > Other Devices > DMS.
Step 2
Click the Other Devices radio button.
Step 3
Click the DMS tab.
Step 4
Check the Enable DMS check box.
Step 5
OL-16441-01
Display (optional)
Camera
Display
Document Camera
(optional)
Network Presentation Audio (optional)
IP Phone
Base Station (optional)
Right Speaker
Cisco Digital Media Player
Figure 2-2
DMP Audio or
Headset or
Bluetooth-enabled
Microphone
Left Speaker
Cisco TelePresence System
for the
2-3