Chapter 14 Completing Installation Of The Main Display Structure - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Completing Installation of the Main Display
Structure
Revised: May 20, 2015, OL-27038-01
Install the right rear panel by completing the following steps:
Step 1
a.
If the hanger is difficult to engage, you can slide the panel in from the side of the system.
Tip
b.
c.
Key Part Description
1 Right rear panel
2 M8 x 16mm pan head screws
3
M8 clear plastic washer
4 Magnet
5
Screw slots
OL-27038-01
Hook the hanger (callout 7 in
on the display assembly as shown in
Add the M8 clear plastic washers to the M8 x 16mm screws, then insert the screws and washers
through the screw slots (callout 5
Figure 14-3.
Secure, but do not fully tighten, the screws and washers with a #4 Phillips screwdriver or driver bit.
Attach the top row of screws first, then the bottom row of screws. The holes are shown in
Figure 14-3.
Make sure that the stop blocks (callout 6 in
the display structure, and that the hanger is engaged with the display structure bracket.
Part Number
700-37186-01
Kit # 69-2311-xx
48-3012-01
Kit # 69-2365-xx
Subkit #
53-3789-xx
49-1377-01
Kit # 69-2369-xx
Subkit #
53-3789-xx
N/A
N/A
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
C H A P T E R
Figure 14-1, and callout 2 in
Figure 14-2.
Figure 14-1) and into the display structure as shown in
Figure 14-1) are pushed against the magnet bracket on
Qty Ctn
1 4
4 6
4 6
N/A
N/A
14
Figure 14-2) of the panel into the bracket
Notes
Part of the panel
Part of the panel.
14-1