Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 195

Chapter 11 Completing Installation of the First Row Table
Assemble the table sections by completing the following steps:
Step 2
a.
Caution Never place the table sections upside-down; you could damage the wood finish on the table top.
b.
c.
d.
e.
USE THE CORRECT M8 x 16mm SCREWS FOR THIS STEP.
Caution
shoulder washers. Using incorrect, longer screws can cause leveling problems with the table sections.
Key Part Description
1
Half-moon table joiners
2 Wooden biscuits
3 Joint plates
4 M8 x 16mm screw
OL-27038-01
Lay the table top parts on top of the table structure the correct way up and slightly offset from their
final position.
Lay only two table sections on the table at a time.
The images in Figure 11-2
One person may have to support the parts while the other person joins the table tops using the
following steps.
Install five wooden biscuits (callout 4) into the slots; then, gently push the table sections together.
Position the 2 half-moon table joiners (callout 3) and tighten them to bring the tables together.
Attach two joint plates (callout 5) using 12 screws (callout 6).
Repeat steps b. through d.
Part Number
51-6068-01
Kit # 69-2300-xx or
69-2344-xx
700-23909-01
Kit # 69-2298-xx
700-23345-01
Kit # 69-2332-xx
48-2430-01
Kit # 53-3789-01
Subkit #
69-2353-xx
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
are shown upside-down for clarity.
for the other table joint.
Qty Ctn
4 44
10 44
1 2
24 6
The correct screws do not have
Notes
Kit number depends on the
type of table finish you
ordered (maple is Kit
#69-2300-xx, walnut is Kit #
69-2344-xx)
11-3