Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 409

Chapter 17 Field-Replaceable Unit Guide
If you install the new codec as the primary codec, the Cisco Unified Communications Manager (Unified
CM) automatically upgrades the software to release 1.9.0. Release 1.9.0 must already be installed on the
Unified CM for the automatic upgrade to occur.
If you install the new codec as a secondary codec, you must upgrade the software manually. When you
boot up the new codec, note the following on the first-time setup screen:
CTS software release number
•
MAC address of the codec
•
If the release is pre-1.9.0, follow this procedure:
Ensure that release 1.9.0 or later is installed on your Unified CM:
Step 1
Log in to the Cisco Unified OS Administration interface of the Cisco Unified CM.
a.
From the Software Upgrades drop-down menu, choose TFTP File Management.
b.
In the Find TFTP Files field, enter "1-9-0" to search for 1.9.0 releases. An appropriate file for the
c.
new codec must end in ".P2.SPA" (for example, "CTS.1-9-0-46R-K9.P2.SPA").
Note
Register the new codec with the Unified CM:
Step 2
a. Connect the Ethernet cable from the uplink port on the back of the new codec to any port with
network connectivity.
Log in to the Cisco Unified CM Administration interface.
b.
c. In the Device drop-down menu, choose Phone.
d. Click Add New.
e. In the Phone Type drop-down menu, choose a Cisco TelePresence system name. Although your
system is a TX9000, we recommend that you choose "Cisco TelePresence 500-32" for the purposes
of upgrading the software.
Click Next.
f.
In the Phone Configuration page, enter the MAC address of the codec. Configure and save all
g.
additional required settings.
Note
Step 3 Upgrade the codec to release 1.9.0 or later in the Unified CM administration interface:
In the Device drop-down menu, choose Phone.
a.
Find the codec that you registered in
b.
OL-27038-01
Replacing a Codec—Part Number CTS-CODEC-PRI-G2R= or CTS-CODEC-PRI-RCH= (PRC)
If you need to install release 1.9.0 on the Unified CM, see steps 1 through 15 in the "Upgrading
from Cisco TelePresence Software Release 1.7.4 and Above" section in this guide:
http://www.cisco.com/en/US/docs/telepresence/cucm_cts/cucm_cts_admin_book/guide/cucm_
cts_admin_touchfeat.html
For more information about these settings, see the "Configuring Cisco Unified Communications
Manager for the Cisco TelePresence System" in this guide:
http://www.cisco.com/en/US/docs/telepresence/cucm_cts/cucm_cts_admin_book/guide/cucm_
cts_admin_config.html
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Step 2.
17-17