Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 342

Attach the upper and lower outer privacy panels by completing the following steps:
Step 11
a.
b.
Note
c.
Note
d.
Key Part Description
1 Center lower privacy panel (outer)
2 Center upper privacy panel (outer)
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
14-28
Set the lower privacy panel into its lower channel, then rotate it upward into place.
This panel attaches to the table assembly with ball studs.
Attach the upper privacy panel.
This panel attaches to the table assembly with magnets.
Make sure that you do not pinch any cables during this procedure.
Pull the presentation and Cisco Touch cables out from the exit hole in the table until there is 8 feet
(2.4 meters) of slack in the cables. Installing the privacy panels can cause the cables to lose slack.
Creating this slack allows the presentation cable and, when connected, Cisco Touch device to
reach the farthest conference participant.
Pull the cables in and out from their exit hole in the table. If the cables do not enter and exit
smoothly, open the outer privacy panels and check the cable routing inside the table to see if the
cables are pinching or catching.
Part Number
700-37272-01
Kit # 69-2333-xx
700-37177-01
Kit # 69-2327-xx
Chapter 14 Completing Installation of the Main Display Structure
Qty Ctn Notes
1 10
1 7
OL-27038-01