Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 145

Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Install the light control unit (LCU), the audio/video extension unit, and the camera power supply to the
Step 8
center electronic equipment bracket. Use M4 nuts to install the units and a 7mm wrench to install the
keps nuts.
Note the orientation of the units:
•
•
•
Key Part Description
1
Light control unit
2 Audio/video extension unit
3 M4 keps nut
4 Camera power supply
OL-27038-01
Install the LCU so that the light connections are on top.
Install the audio/video extension unit so that the microphone connectors are on the left.
(Not shown) Install the camera power supply directly to the right of the notch in the electronic
equipment bracket. The notch is in the center of the bracket, just to the right of the light control unit
after you install it.
Part Number
CTS-LCU-G2R
800-33995-01
CTS-LAEB-G2R
800-36423-01
49-0420-01
Kit # 69-2377-01
CTS-TX9K-CAM-PWR
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Qty Ctn Notes
1 30
1 31
6 6 These nuts have ridges on
the perimeter.
1 11 Not shown in Figure 8-7
8-9