Installing And Leveling The Display Structure - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Installing and Leveling the Display Structure

Installing and Leveling the Display Structure
To install and level the display structure, complete the following steps.
Step 1 Place the center display structure in its correct position in the room, then level the structure in the
following manner:
•
•
•
Systems With a Wall-Mounted Reflector Wall Only
Position the center structure so that it is 16 inches (406 millimeters) away from the wall.
Systems With a Free-Standing Reflector Wall Only
Position the center structure so that it is a minimum of 22 11/16 Inches (576 millimeters) away from the
wall.
Placing the wall closer to, or further from, the wall can result in fit issues or a non-working system.
Note
Key Part Description
1 Display stand, center
2 Wall
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
4-2
Align the structure front to back.
Align the structure left to right.
See the levels in Figure 4-3
Use the adjustable feet at the base of the structure so that the distance between the top of the display
support arm to the floor is the measurement that is shown in
Part/Kit Number
800-37616-01
Kit #69-2323
N/A
Chapter 4 Installing And Performing Initial Leveling of the Main Display Structure
for leveling examples.
Qty Ctn
1 1
Figure 4-3.
Notes
If your installation uses a
wall-mounted reflector wall, use
the wall as a reference, not the
reflector.
OL-27038-01