Assembling The Second Row Table - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Assembling the Second Row Table

Assembling the Second Row Table
To assemble the second row table, complete the following steps.
Step 1 Unpack each table leg.
Step 2 Set the table legs upside-down and place them in approximately the position where they are during the
final installation. Use
Check the label on top of the each legs to determine the placement.
Tip
With the leg still upside-down, measure the gap between the hex nut on the leveling foot and the
Step 3
structure.
If required, adjust the nut until the distance between the hex nut and the structure is 22mm.
Step 4
Figure 12-2 Adjusting the Leveling Feet on the Table Legs
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
12-2
Chapter 12
Figure 12-1 to determine where to place the table legs.
Building the Second Row Table (TX9200 Systems Only)
OL-27038-01