Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 375

Chapter 15 First-Time Setup
Loosen the thumbscrew on the zoom ring on the camera lens.
Step 2
The zoom ring is labeled "W-T". See
Using the zoom ring, and the left/right, up/down, and rotation adjustment screws on the camera, perform
Step 3
the following adjustments to the center camera:
•
•
•
Note
Figure 15-6
OL-27038-01
Align the red plus sign to the plus sign in the middle of the target.
Align the red hash marks on the display so that they fit between the table edges.
Zoom and align the camera so that the curved lines on each side of the target touch the sides of
the display as shown in Figure
To adjust the camera left and right or up and down, or to make vertical adjustments, use the
adjusting screws as shown in
If one of the left/right screws is covered by the camera cable, use the other screw to make
all left/right adjustments.
Camera Adjustment Screws
Left
adjust
screw
Camera
rotation
screw
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Figure 15-12 for the location of the zoom ring.
15-7.
Figure 15-6.
Right
adjust
screw
Camera
rotation
screw
Lens
Up/down
adjust
screw
Setting Up CTS Components
15-13