Setting Date, Time And Location - Cisco EX Series Getting Started Manual

Cisco TelePresence Video Systems
Contents

Setting date, time and location

(When not set by a provisioning system)
You should check that the date and time settings are correct
when you set up your video conference system. The system
uses this information for example to time stamp messages
transmitted to gatekeepers and other network elements.
You can find the time in the top right corner of the Touch
controller display.
Back to task overview
D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.
Introduction User interfaces
1. Tap the user name in the upper left corner and tap
> Date, Time &
2. Tap 24h or
3. Tap dd.mm.yy,
Format you prefer.
4. Select the
of available zones by tapping the - or + signs.
5. Set Date & Time Mode
be regularly updated; otherwise, select Manual.
a. If you select Manual, enter the correct value for Hour,
Minute, Year, Month, and Day. Tap the - and + signs to
increase or decrease a value.
b. If you select Auto, the NTP server address can be
automatically obtained from the network (set the
Mode
yourself (set
6. Tap Save to confirm the changes, or
saving.
7. Tap Exit to return to the home menu.
Configuration Configuration
Settings
Location.
12h to select the Time Format you prefer.
mm.dd.yy or yy.mm.dd to select the
OlsonZone for your system. Step through the list
to Auto if you want time and date to
to Auto) or you can enter the NTP Server address
NTP Mode to Manual).
Undo to leave without
16
Appendices
Date
NTP
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts