Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 151

Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Level the front facade brackets using a laser level across the six diamond-shaped holes (two in each
Step 10
bracket). If the brackets are not level, use the lowest diamond-shaped hole as a base line, and move the
other brackets down until they are level.
Note If you cannot level the brackets, loosen the screws and make sure that the brackets are pushed up as high
as possible into the structure, then retighten the screws.
Figure 8-13 Leveling the Front Facade Brackets
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
8-15
OL-27038-01