Pre-Installation Checks; Checking The Physical Condition Of System Packaging; Checking The Function Of The 65-Inch Display Prior To Installation - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 1 Overview, Required Tools, Preinstallation Checks, and List of Hardware Fasteners
•
•

Pre-Installation Checks

Before you install the system, you must perform the following pre-installation checks:
•
•

Checking the Physical Condition of System Packaging

Items should be received at the installation site with the packaging in good condition. In particular,
display packaging should be undamaged, and the tilt indicators on the displays should show that the
displays have remained upright during transit.
If you see any damage to the system packaging prior to installation, document the damage by taking
pictures and contact the Cisco Technical Assistance Center (TAC) before you begin installation.

Checking the Function of the 65-Inch Display Prior to Installation

Reports from installers in the field have indicated that some displays are not functional after they are shipped to
the installation site.
after you remove the cardboard overpack, but before you completely remove the display from its packaging.
To perform the display integrity check, complete the following steps:
Remove the outer box from the display packaging.
Step 1
You can leave the display in the rest of its packaging for this check, as long as you can access the power
Note
cord outlet and the DVI connectors on the lower part of the display.
OL-27038-01
Wall-mounted reflector wall systems only:
Appropriate fasteners depending on your type of wall (concrete, concrete block, brick, or
–
drywall). All types of walls require an anchor. If your wall is drywall, it is recommended that at
least 2 screws per L bracket go through the stud.
– Jigsaw and drill bit (for cutting outlet holes in the reflector, if required).
(Optional) furniture sliders
You can use furniture sliders (flat plastic pieces) to place under items you need to move. For
example, you can place the sliders under the table legs if you need to move the second row table for
TX9200 systems.
Checking the Physical Condition of System Packaging, page 1-3
Checking the Function of the 65-Inch Display Prior to Installation, page 1-3
To avoid installing a non-functional display, perform a pre-installation check on the displays
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Pre-Installation Checks
1-3