Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 405

Chapter 17 Field-Replaceable Unit Guide
Remove the camera cluster.
Step 12
See Figure 8-19
Remove the top mounting bezel bracket above the display.
Step 13
See Figure 7-2
Remove the bottom mounting bezel bracket below the display.
Step 14
See Figure 7-4
Remove the facade brackets connected to the display.
Step 15
See Figure 5-4
Open the vertical bezel clips.
Step 16
See Figure 7-3
Remove the eight vertical bezel brackets from the rear of the center display.
Step 17
See Figure 7-8
Step 18 Remove both vertical bezels from center display.
See Figure 7-7
Disconnect display cables.
Step 19
Loosen mounting spools on rear of display.
Step 20
See Figure 5-1
Remove display.
Step 21
See Figure 5-2
Remove mounting spools and hardware from existing display
Step 22
See Figure 5-1
Install mounting spools onto replacement display.
Step 23
Install four facade brackets onto replacement display.
Step 24
Using two people, mount replacement display onto frame.
Step 25
Step 26 Connect display cables.
Step 27 Install vertical bezels to rear of replacement display.
Step 28 Install eight vertical bezel brackets, securing the vertical bezels.
Close vertical bezel clips.
Step 29
Install bottom mounting bezel bracket.
Step 30
Install top mounting bezel bracket.
Step 31
Connect speaker cables.
Step 32
Install the camera cluster.
Step 33
Attach the three camera cables to the camera processor. See
Step 34
connector to attach each camera cable.
OL-27038-01
for more information.
for more information.
for more information.
for more information.
for more information.
for more information.
for more information.
for more information.
for more information.
for more information.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Replacing the Center Display—Part Number CTS-DISP-65-GEN4=
Table 17-5 for information about which
17-13