Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 78

Installing and Leveling the Display Structure
Using a laser level, perform initial leveling of the structure by leveling the horizontal cross-bars of all
Step 8
structures, then tighten all screws.
Tighten all horizontal screws first, then tighten all vertical screws.
An alternative leveling method is to place a bubble level on all horizontal cross-bars.
Step 9
Since the assembly is one unit, take care not to raise the leveling feet off the floor while raising or
Note
lowering the leveling feet.
Figure 4-12 Raising and Lowering the Feet To Level the System
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
4-14
Chapter 4 Installing And Performing Initial Leveling of the Main Display Structure
OL-27038-01