Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 213

Chapter 12 Building the Second Row Table (TX9200 Systems Only)
Join table leg H, table leg I, and the privacy panel bracket together by completing the following
Step 5
procedure:
Note
a. Attach a privacy panel bracket (callout 1 in
3).
The lettering scheme for the table legs is shown in
Line up the alignment pins to the holes and attach the panel with eight M8 x 16mm screws (callout
b.
4).
These screws, and all screws that attach the privacy panel to the table legs, attach from the rear of
the system.
and facing the second row.
Check that the top surface of each leg are the same height and are level by placing levels on the
c.
following places:
Set a level on the side of the leg to align the legs vertically.
•
Set a level on top of the table leg, both parallel to and perpendicular to the table leg.
•
Note
Do not fully tighten all the screws until you attach all of the table sections.
Tip
Caution USE THE CORRECT M8 x 16mm SCREWS FOR THIS STEP.
shoulder washers.
OL-27038-01
For this step and all successive steps, slightly peel back the protective film on the table legs
(enough to expose the space where the structure and the legs join together).
Figure 12-3 shows the table legs as if you were standing from the front of the system
You can also use a laser level for this step.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
Assembling the Second Row Table
Figure 12-3) in between leg H and leg I (callouts 2 and
Figure 12-1.
The correct screws do not have
12-3