Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual page 160

Install the cable runner base to the display assembly by completing the following steps:
Step 15
a.
b.
c.
Key Part Description
1
Cable runner base
2
M6 x 16mm screws
3
Guide pin
Figure 8-20 Installing the Cable Runner Base
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
8-24
Chapter 8 Assembling the Electronic Hardware, Facade Brackets, Camera Assembly, and Cable Runner
Lay the cable runner base on the floor, being careful not to strike the displays.
Align the base bracket with the guide pin. The guide pins are below the screws in
Assemble the runner to the display assembly by using M6 screws.
Part Number
700-37314-xx
Kit# 69-2323-xx
48-3000-xx
Kit #69-2356-xx
N/A
Figure
Qty Ctn Notes
1 1
2 6
N/A Part of display assembly
8-20.
OL-27038-01