Configuring An Alternate Tftp Server (Optional); Setting Up A Tx9000 Or Tx9200 System That Uses A Static Network Address - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Chapter 15 First-Time Setup
Tip If you did not make a note of the IP address and it no longer appears on the display, follow the
instructions in
page 15-5
Log in to the system by entering the following information:
Step 8

Configuring an Alternate TFTP Server (Optional)

If you need to use an alternative TFTP server, configure the parameters for the alternative TFTP server
and in the Cisco Unified Communications Manager (Unified CM) Device page. For instructions to
configure an alternate TFTP server, refer to the
of the
If you are using the TFTP address that DHCP supplies for Cisco Unified Communications Manager, do
Note
not perform this action.
Setting Up a TX9000 or TX9200 System That Uses a Static
Network Address
If your system does not use the Dynamic Host Configuration Protocol (DHCP) to obtain an address and
uses a statically-assigned IP address, use the following procedure to assign the static address to the
system.
Make sure that the system is disconnected from the network.
Step 1
Wait for the system to finish booting and for the 192.168.x.x address to appear on the center display.
Step 2
Make a note of the IP address that displays.
Step 3
Disconnect the auxiliary camera port connection on TS1 (the primary codec).
Step 4
Connect a DHCP-enabled PC to the auxiliary camera port of the primary codec. The connection on the
Step 5
port is the Ethernet port labeled "Aux" with a camera icon next to it. The port is on the far lower right
in Figure
Figure 15-3 Aux Camera Port Location
OL-27038-01
Step 5 and Step 6
to retrieve it.
Username: admin (case sensitive)
–
Password: cisco (case sensitive)
–
Cisco TelePresence System Administrator's Guide
15-3.
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
in the "Configuring an Alternate TFTP Server (Optional)" section on
"Configuring the Cisco TelePresence
for your software release.
Configuring an Alternate TFTP Server (Optional)
System" chapter
15-5