Installation Overview; Instructions For Systems That Use A Wall-Mounted Reflector Wall - Cisco TelePresence System TX9000 Assembly, Use & Care, And Field-Replaceable Unit Manual

Installation Overview

Check the LED on the front of the screen and the display screen and perform one of the following
Step 7
actions:
•
Figure 1-7
•
Note
Installation Overview
The order of steps differ depending on your type of system:
•
•

Instructions for Systems That Use a Wall-Mounted Reflector Wall

To install a system that uses a wall-mounted reflector wall, follow this order:
Install the reflector wall to the wall of the room by going to
Step 1
Reflector Wall Structure,"
Cisco TelePresence System TX9000 and TX9200 Assembly, Use & Care, and Field-Replaceable Unit Guide
1-10
Chapter 1
If the LED on the front of the display is green, the display shows a multicolored pattern, and the
Checksum data shows "15FC" on the upper left side of the screen, press the Factory Mode button
again and reattach the factory mode cover. You are finished with this procedure, and this display is
ready to be installed.
Checksum Value
If the LED is orange, or the display remains blank, double-check the signal cable coming in to the
DVI connection. If the LED remains orange, report the problem to Cisco technical support.
If the LED is flashing, make a note of the flashing pattern and report the pattern to Cisco
technical support.
To install a system that uses a wall-mounted reflector wall, see the
Use a Wall-Mounted Reflector Wall" section on page 1-10
To install a system that uses a free-standing reflector wall, see the
Use a Free-Standing Reflector Wall" section on page 1-11
and complete the steps in that chapter.
Overview, Required Tools, Preinstallation Checks, and List of Hardware Fasteners
Chapter 3, "Installing the Wall-Mounted
"Instructions for Systems That
for the order of steps.
"Instructions for Systems That
for the order of steps.
OL-27038-01