Juniper MX2010 Hardware Manual page 121

Table 32: Supported MX2010 Power System Components (continued)
Name
AC PSM
Three-phase delta AC PDM
Three-phase wye AC PDM
Nine-feed single-phase AC PDM
Seven-feed single-phase AC PDM
NOTE: Routers configured with AC or DC PDMs and PSMs are shipped with blank panels
installed.
NOTE: To avoid triggering any PSM-related or power-related alarms for the PSMs that are not
used but still plugged into the MX2010 router, make sure that you:
Do not connect external power feeds to the PSM through the PDM.
Move the DIP switch on the PSMs to the off position.
Turn off the PSM by using its ON/OFF switch.
RELATED DOCUMENTATION
MX2000 AC Power Supply Module Description | 107
MX2000 Three-Phase Delta AC Power Distribution Module Description | 100
MX2000 Three-Phase Wye AC Power Distribution Module Description | 102
MX2000 Seven-Feed Single-Phase AC Power Distribution Module Description | 105
MX2000 Nine-Feed Single-Phase AC Power Distribution Module Description | 106
MX2010 DC Power Distribution Module (-48 V) Description | 111
MX2010 DC Power Supply Module (-48 V) Description | 116
MX2010 AC Power Requirements | 161
MX2010 DC Power Requirements | 189
Model Number
MX2000-PSM-AC
MX2000-PDM-AC-DELTA
MX2000-PDM-AC-WYE
MX2K-PDM-AC-1PH
MX2K-PDM-OP-AC
Junos OS Release
12.3R2 and later
12.3R2 and later
12.3R2 and later
15.1R1 and later
15.1R1 and later
99