Juniper MX2010 Hardware Manual page 168

Table 45: MX2010 Site Preparation Checklist (continued)
Item or Task
Verify that your rack meets
the minimum requirements for
the installation of the router.
Plan rack or cabinet location,
including required space
clearances.
NOTE: If you are installing the
MX2010 router into a network
cabinet, make sure that no
hardware, device, rack, or
cabinet component obstructs
the 34-U rack space from
access during installation.
If a rack is used, secure rack to
floor and building structure.
Cables and Transceivers
Acquire cables and
transceivers:
Determine the number of
cables needed based on
your planned configuration.
Review the maximum
distance allowed for each
cable. Choose the length of
cable based on the distance
between the hardware
components being
connected.
Plan the cable routing and
management.
For More Information
"MX2010 Rack Requirements"
on page 135
"MX2010 Cabinet Size and
Clearance Requirements" on
page 128
"MX2010 Cabinet Size and
Clearance Requirements" on
page 128,
"MX2010 Rack Requirements"
on page 135,
"Clearance Requirements for
Airflow and Hardware
Maintenance for the MX2010
Router" on page 147
"MX2010 Rack Requirements"
on page 135
"Understanding Fiber-Optic
Cable Signal Loss, Attenuation,
and Dispersion" on page 153
"Calculating Power Budget and
Power Margin for Fiber-Optic
Cables" on page 151
"Maintaining Cables That
Connect to MX2010 MPCs or
MICs" on page 607
Performed By Date
146