Juniper MX2010 Hardware Manual page 467

Figure 215: Removing the Card-Cage Cable Manager Air Filter
To remove the PSM air filter—MX2000-FLTR-PWR:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Loosen the two captive screws located on either side of the air filter and pull slightly out of the chassis.
CAUTION:
in place.
3. Grasp the PSM air filter, and pull the air filter straight out from the chassis.
4. Slide the air filter out of the chassis as shown in
NOTE: The AC–powered MX2010 router has the same air filter.
Do not run the router for more than 2 minutes without the air filter
Figure 216 on page 452.
451