Juniper MX2010 Hardware Manual page 472

456
Figure 221: Installing the Card-Cage Cable Manager Air Filter
5. Push the air filter in place, close the door, and tighten the two captive screws.
6. Replace the cables in the card-cage cable manager, if necessary.
To install the PSM air filter—MX2000-FLTR-PWR:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Ensure that the air filter is right side up.
3. Grasp the PSM air filter and insert into the chassis until it stops, (see Figure 156 on page 364).
4. Tighten the two captive screws to secure.
NOTE: The AC–powered MX2010 router has the same air filter.