Juniper MX2010 Hardware Manual page 332

10. Verify that the PWR OK LED is lit green steadily, indicating that the PSM is correctly installed and
functioning normally.
NOTE: After a PSM is powered on, it can take up to 60 seconds for status indicators—such
as the status LEDs on the PSM and the show chassis command display—to indicate that
the PSM is functioning normally. Ignore error indicators that appear during the first 60
seconds.
If any of the status LEDs indicates that the PSM is not functioning normally, repeat the installation and
cabling procedures.
11. Verify that the INP0 or INP1 LEDs on the PSM are lit green steadily if using two feeds.
NOTE: The DIP switches 0 and 1 must be set to the ON position for a two-feed installation.
12. On the external management device connected to the CB-RE, monitor the startup process to verify
that the system has booted properly.
NOTE: If the system is completely powered off when you power on the PSM, the Routing
Engine boots as the PSM completes its startup sequence. Normally, the router boots from
the Junos OS on the CompactFlash card.
To power off the system after the Routing Engine finishes booting, see
DC-Powered MX2000 Router" on page
13. Verify the MX2010 router power up, system initialization, and status (see
MX2010 Router" on page
RELATED DOCUMENTATION
Connecting the MX2010 Router to Management and Alarm Devices | 337
Preventing Electrostatic Discharge Damage to an MX Series Router
Replacing an MX2010 DC Power Supply Module (-48 V) | 475
Replacing an MX2000 DC Power Distribution Module (-48 V) | 484
698.
351).
"Powering Off the
"Initially Configuring the
316