Juniper MX2010 Hardware Manual page 317

Figure 128: Plugging into the MX2000 Single-Phase AC Power Distribution Module
7. Replace the power cord retainer, making sure the power cords do not touch or block access to router
components.
8. Flip the power switch on each PSM to the on (|) position to provide power to the router components.
9. Verify that the LEDs on the PDM faceplate are lit steadily green, indicating that the AC terminal block
is receiving power.
10. Remove the ESD grounding strap from the ESD points on the chassis. Connect the strap to an approved
site ESD grounding point. See the instructions for your site.
WARNING:
dangerous voltages.
RELATED DOCUMENTATION
Installing an MX2000 Single-Phase AC Power Distribution Module | 422
Removing an MX2000 Single-Phase AC Power Distribution Module
MX2000 Single-Phase AC Power Distribution Module Electrical Specifications | 180
Powering Off the AC-Powered MX2000 Router | 697
MX2000 AC Power Cord Specifications | 170
MX2000 AC Power System Electrical Specifications | 173
MX2000 Seven-Feed Single-Phase AC Power Distribution Module Description | 105
MX2000 Nine-Feed Single-Phase AC Power Distribution Module Description | 106
Do not touch the power connectors on the PDM. They can contain
301