Juniper MX2010 Hardware Manual page 358

Connecting MPC or MIC Cables to the MX2010 Router | 348
Connecting an MX2000 Router to a Console or Auxiliary Device | 338
Connecting the MX2010 Router to a Network for Out-of-Band Management | 337
CB-RE and RCB Interface Cable and Wire Specifications for MX Series Routers | 155
Connecting the MX2010 Router to a Network for Out-of-Band Management
To connect the CB-RE to a network for out-of-band management, connect an Ethernet cable with RJ-45
connectors to the MGMT port on the CB-RE interface. One Ethernet cable is provided with the router.
To connect to the MGMT port on the CB-RE interface:
1. Turn off power to the management device.
2. Plug one end of the Ethernet cable
on the CB-RE interface.
Ethernet ports.
3. Plug the other end of the cable into the network device.
Figure 143: Out-of-Band Management Port
1 2 3
Figure 144: Out-of-Band Management Cable Connector
Table 87: Out-of-Band Management Port on the MX2010 CB-RE
Function No.
3
(Figure 139 on page 338
Figure 138 on page 338
Label
MGMT
shows the connector) into the MGMT port
shows the port. Table 84 on page 338
Description
Dedicated management channel for device
maintenance. It is also used by system
administrators to monitor and manage the
MX2010 remotely.
342
describes the