Juniper MX2010 Hardware Manual page 334

If any of the status LEDs indicates that the PSM is not functioning normally, repeat the installation and
cabling procedures.
11. Verify that the INP0 or INP1 LEDs on the PSM are lit green steadily if using two feeds.
NOTE: The DIP switches 0 and 1 must be set to the ON position for a two feed installation.
12. On the external management device connected to the Control Board and Routing Engine (CB-RE),
monitor the startup process to verify that the system has booted properly.
NOTE: If the system is completely powered off when you power on the PSM, the Routing
Engine boots as the PSM completes its startup sequence. Normally, the router boots from
the Junos OS on the CompactFlash card.
To power off the system after the Routing Engine finishes booting, see
DC-Powered MX2000 Router" on page
13. Verify the MX2010 router power up, system initialization, and status, see
MX2010 Router" on page
RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX2020 Router
Replacing an MX2000 DC Power Supply Module (240 V China) | 480
Replacing an MX2000 DC Power Distribution Module (240 V China) | 490
698.
351.
"Powering Off the
"Initially Configuring the
318