Juniper MX2010 Hardware Manual page 288

To install the MX2010 in an open-frame rack by using a router transport kit:
1. Using the router transport platform, position the router in front of the rack or cabinet, centering it in
front of the rack.
2. Using a four-person team, transport the router to the rack installation location and center it in front of
the rack.
NOTE: A minimum of 38 in. (96.5 cm) of clearance is required to roll the chassis sideways.
NOTE: A minimum of 42 in. (106.7 cm) of circular space is required to rotate the chassis.
NOTE: The router transport kit handles can be removed to accommodate aisle width.
3. Adjust the height of the router by turning the handles clockwise until the router transport platform is
approximately 0.75 in. above the bottom of the rack opening (see
NOTE: Because of the short lift capability of the router transport kit, we recommend that
you install the router on the bottom of the rack.
NOTE: Make sure that the bubbles within the T-shaped levels are between the lines,
indicating that the router is level.
4. Adjust the four leveling mounts on the router transport platform until all four leveling mounts rest
firmly on the ground (see Figure 110 on page 272).
Figure 110 on page 272).
271