Figure 189: Selecting DC Power Subsystem Feed Redundancy
PWR OK FAULT
INP0
INP1
3. Using both hands, grasp the handle and slide the PSM straight into the chassis until the PSM is fully
seated in the chassis slot. Tighten the two captive screws (see
Figure 191 on page
408) (MX2010), or
(1.13 Nm) to 12 lb-in. (1.35 Nm) of torque to each screw. Do not overtighten the screws.
ON
0
1
Figure 188 on page 406
Figure 190 on page 408
(MX2008). Apply between 10 lb-in.
407
(MX2020) and