Juniper MX2010 Hardware Manual page 35

NOTE: Remove field replacement units (FRUs) from the front of the MX2010 router before you
install the router.
See Table 3 on page 9 for information about the components on the front of the MX2010 router.
Table 3: Front Components in a Fully Configured MX2010 Router
Component No.
1
2
3
4
5
NOTE: A combination card-cage cable manager and air filter is installed over the CB-REs and
SFBs.
NOTE: Remove field replacement units (FRUs) from the rear of the MX2010 router before you
install the router.
See Table 4 on page 10 for information about components on the back of an AC-powered MX2010 router.
Component Description
Craft interface
Card-cage air filter
Control Board and Routing
Engine (CB-RE)
Switch Fabric Boards
(SFBs)
MPCs with ADCs and
MICs
Slots
–
–
0 and 1
0 through 7
0 through 9
Number of FRUs
1
1
2
8
10
9