Juniper MX2010 Hardware Manual page 272

6. On each of the shipping brackets, partially insert screws into the hole to secure the brackets to the
chassis. Tighten all screws. These brackets will prevent the chassis from tilting.
7. Lower the pallet jack before moving the chassis. This will help distribute the weight evenly and reduce
the risk of tilting or damage to the chassis.
8. Using the pallet jack, position the router in front of the rack or cabinet, centering it in front of the rack.
NOTE: If you are installing the MX2010 router into a network cabinet, make sure that no
hardware, device, rack, or cabinet component obstructs the 34-U rack space from access
during installation.
9. Using the pallet jack, lift the chassis approximately 0.75 in. (1.9 cm) above the surface of the mounting
shelf (four-post rack) or bottom opening of the rack (open-frame rack), and position it as close as
possible.
NOTE: Due to the short lift capability of the pallet jack, we recommended that you install
the router on the bottom of the rack.
10. Remove the shipping brackets that are attached to the pallet jack attachment and chassis, and set them
aside.
11. Grasp the handles on the shipping covers and carefully slide the router into the rack (see and
Figure 98 on page 256
continue sliding the router onto the mounting shelf so that the bottom of the chassis and the mounting
shelf overlap by approximately 2 inches.
and Figure 99 on page 257). If you are installing the router into a four-post rack,
255