6. Grasp the craft interface faceplate and carefully tilt it toward you until it is horizontal.
7. Disconnect the ribbon cable from the back of the faceplate by gently pressing on both sides of the
latch with your thumb and forefinger.
8. Gently slide the left end of the craft interface out of the housing. The pin at the right end of the craft
interface will auto-slide out of the dedicated hole. Refer to
Figure 237: Sliding the Craft Interface Out of the Housing
9. Remove the craft interface from the chassis. See
Figure 237 on page
1
Figure 238 on page
472.
471.
471