Juniper MX2010 Hardware Manual page 768

Using a router transport kit:
Position the router transport platform in front of the rack, and adjust the four leveling mounts using
an 8 mm Allen wrench to align the platform with the bottom of the mounting shelf and the chassis.
Unscrew and remove the mounting screws from the front mounting flange on the rack.
A minimum of four people can then slide the router onto the router transport platform by using the
handles on the shipping covers.
Secure the four toggle latches to the router transport platform.
Using a two person team, adjust the height on the router transport platform to install the router
transport mounting plates and wheel assembly.
WARNING:
make the router unstable.
Attach the router transport mounting plates and wheel assembly to both sides of the chassis using
the captive screws, tighten to secure.
NOTE: You may have to adjust the wheel assembly to installed the router transport
mounting plates.
Using a two person team, crank the handles 4-5 times until the router is lifted approximately 1 in.
(2.54 cm).
WARNING:
so can make the router unstable during transport.
Unlatch the four toggle latches that secure the router transport platform to the router mounting
plate and wheel assembly.
Remove the router transport platform away from the bottom of the router, and set aside
Position the crate door in front of the shipping crate and secure the two latches.
Guide the router up the ramp and into the shipping crate.
Lower the router until the chassis is resting firmly onto the shipping crate platform.
Remove the router transport mounting plates and wheel assembly from the chassis.
Do not raise the router more than 1 in. (2.54 cm). Doing so can
Do not raise the router transport over the required limit. Doing
755