Juniper MX2010 Hardware Manual page 722

Table 101: MX2010 Cooling System Alarms (continued)
Component
Temperature sensors
RELATED DOCUMENTATION
MX2010 Craft Interface Description | 29
Replacing an MX2010 Fan Tray | 508
Maintaining the MX2010 Air Filters | 609
Maintaining the MX2010 Fan Trays | 615
Alarm
Type CLI Message
Red Temperature Hot
Temperature sensor
failure
Yellow Temperature Warm
Alarm Condition Solution
The chassis Verify that the
temperature room temperature
exceeded the hot is within
temperature acceptable limits.
threshold. If this
Verify that there
condition persists, the
is sufficient air
router shuts down.
flow.
Verify that the
cooling system in
the chassis is
operating
properly.
A temperature sensor Contact JTAC
failed.
The chassis Verify that the
temperature room temperature
exceeded the warm is within
temperature acceptable limits.
threshold.
Verify that there
is sufficient air
flow.
Verify that the
cooling system in
the chassis is
operating
properly.
708